Maintenance & Cleaning; Warning And Error Codes - IMEON ENERGY 3.6 Guide De Montage

IMEON INVERTER
8. Maintenance & Cleaning

8.1 Warning and error codes

Warning and error codes In case of a warning or error displayed by the inverter, refer to the table
below before contacting technical support if needed.
Code Type
2 warning_ond Islanding detected. If this problem remains, please contact your grid operator
Grid voltage higher than the limit of the norm. If this problem remains, please contact your
3 warning_ond
grid operator.
Grid voltage lower than the limit of the norm. If this problem remains, please contact your
4 warning_ond
grid operator.
Grid frequency higher than the limit of the norm. If this problem remains, please contact your
5 warning_ond
grid operator.
Grid frequency lower than the limit of the norm. If this problem remains, please contact your
6 warning_ond
grid operator.
Grid voltage lost. Check if the GRID CONNECTION connector is correctly supplied by the
7 warning_ond
public grid. If this problem remains, please contact your grid operator.
Grid frequency lost. Check if the GRID CONNECTION connector is correctly supplied by the
8 warning_ond
public grid. If this problem remains, please contact your grid operator.
9 warning_ond There is a phase rotation problem. Reverse 2 phases and restart the inverter.
Grid sinus lost. Check if the GRID CONNECTION connector is correctly supplied by the
10 warning_ond
public grid. If this problem remains, please contact your grid operator.
Average grid voltage greater than norm voltage for 10 min. If this problem remains, please
11 warning_ond
contact your grid operator.
Overload on the AC BACKUP. Remove the high power devices with inrush power (air
12 warning_ond
conditioner, pumps,...).
High inverter temperature. Please check the good ventilation of your inverter and the
13 warning_ond
temperature in the inverter room.
14 warning_ond Earth default. Please check inverter is correctly connected to the ground.
22 warning_pv
Low PV2 voltage. Check the PV sizing, connection and installation.
PV voltage too high. Check the PV sizing and installation. This problem can cause a critical
23 warning_pv
electronic damage.
PV2 voltage too high. Check the PV sizing and installation. This problem can cause a critical
24 warning_pv
electronic damage.
CPU1 flash failure. Please reboot the inverter and check the version is the last one. If the
25 warning_cpu
problem remains, please contact your distributor.
CPU1 start failure. Please reboot the inverter and check the version is the last one. If the
26 warning_cpu
problem remains, please contact your distributor.
Battery warning reported. Check the battery ID warning in IMEON OS. ONE. If the problem
27 warning_bat
remains contact your battery distributor.
Battery not connected. Please connect the batteries and check if a breaker/fuse is not open
30 warning_bat
between inverter and batteries. If the problem remains contact your battery distributor
Battery voltage too high. Disconnect your battery and check if the battery specifications
32 warning_bat
comply with inverter.
CPU1 communication failure. Please reboot the inverter and check the version is the last
35 error_ond
one. If the problem remains, please contact your distributor.
Internal wiring failure. Please reboot the inverter. If the problem remains contact your
37 error_soft
distributor or IMEON for repair
Software service failure. Please reboot the inverter. If the problem remains, please contact
38 error_soft
your distributor.
Software service failure. Please reboot the inverter. Please reboot the inverter and check the
39 error_soft
version is the last one. If the problem remains, please contact your distributor.
Software service failure. Please reboot the inverter. Please reboot the inverter and check the
40 error_soft
version is the last one. If the problem remains, please contact your distributor.
IMEON_installation_guide_rev D.5
Description
FR
FR
EN
ES
IT
81