Mounting Unit - IMEON ENERGY 3.6 Guide De Montage

IMEON INVERTER
Standard tools can be used for the installation of the IMEON. The following equipment‟s are those
recommended for installation:
 Mounting unit :
o
A drill,
o
6 screws (IMEON 3.6 : 5 to 9 mm ØM5, IMEON 9.12 : 15 to 18 mm ØM10).
 Smart Meter installation :
o
A wire stripper,
o
An Ethernetcable,
o
A flat screwdriverØ2mm.
 Connection to the grid, to solar, to battery, to AC Backup :
o
A wire stripper,
o
A cable cutter,
o
A crimping pliers for PV cables,
o
A crimping pliers for battery cables,
o
A set of flat and cruciform screwdrivers,
o
A multimètre.
 In case of communication via Ethernet:
o
An Ethernet cable,
o
A router.
 Inverter setting :
A connected equipment (smartphone, computer...).
o

3.2.2 Mounting Unit

WARNING: This inverter is heavy! Please be careful when removing it from the package.
 Choose an appropriate place of support.
 Wall fixation should be done with the proper screws so that the solar inverter can be easily
attached. After that, the device should be bolted on securely.
IMEON 3.6
WARNING:Suitable for mounting on concrete or another non-combustible surface only! Take
into account a space for ventilation between the case and the wall.
1. Drill six holes in the marked locations for the six screws.
IMEON 3.6
5 to 9 mm
Ø M5
IMEON_installation_guide_rev D.5
IMEON 9.12
15 to 18 mm
Ø M10
IMEON 9.12
FR
FR
EN
ES
IT
57