IMEON ENERGY 3.6 Guide De Montage page 61

IMEON INVERTER
Step 4: Use two battery cables. Remove 30 mm of the insulation sleeve (a), insert into cable ring
terminal and crimp it with a dedicated crimping tool (H type), then insert it into the connector
(b).
(a)
Step 5: Make sure the cables are correctly connected.
Step 6:Plug the battery connector into IMEON‟s "DC BATTERY"
socket.
Step 7:The battery parameter can be done on IMEON OS. ONE (refer
to inverter configuration section).
WARNING: Do not switch the circuit breaker when the IMEON is under load, it can damage the
inverter.
(b)
IMEON_installation_guide_rev D.5
FR
FR
EN
ES
IT
61