Drm Connection - IMEON ENERGY HV Notice De Montage Et Guide De Montage

Step 4: Insert stripped wires into AC terminal and ensure that all conductors strands are
Step 5: Screw the Phase (L), the Neutral (N) and the Earth (PE) cables into the
FR
EN
FR
Step 6: Screw he "EPS" cable gland.
Step 7: Screw back the top plate of the inverter.

3.10. DRM Connection

DRM is provided to support several demand response modes by emitting control signals
as below.
Note:pin definitions as below.
 DRM Connection Steps:
Please refer to BMS connection steps for RS485 connection. Please kindly note the PIN
definition and port position will be slightly different.
56
IMEON HV
captured in the AC terminal, then compress the AC terminal head by using a
crimping pliers and screw down screw cap tightly.
corresponding terminal blocks of the inverter.
1
DRM1/5 DRM2/6
IMEON HV – Guide d'installation / Installation guide – Rev A.4
2 3 4
DRM3/7 DRM4/8
5 6 7
+3.3V DRM0 GND GND
8