Installation; Selecting Mounting Location; Recommended Equipment - IMEON ENERGY 3.6 Manuel D'installation

IMEON INVERTER

3. Installation

3.1 Selecting Mounting Location

 Do not mount the inverter on flammable construction materials.
 Mount on a solid surface.
 IMEON may possibly be noisy during operation which would be uncomfortable if installed in a
living room area.
 The temperature may cause a reduction of power due to the excessive heating.
 Install the IMEON at eye level in order to allow the LCD display to be read at all times.
 Dusty conditions may impair the performance of this inverter.
 Do not switch IMEON on, if the temperature or the humidity are out of the authorized limits.
The ambient temperature should be between -20°C and +50°C and relative humidity should
be between 0% and 90% to ensure optimal operation.
 For proper air circulation to dissipate heat, allow a clearance of approx. 50 cm to the side and
approx. 50 cm above and below the IMEON.
 For proper operation of this inverter, please use appropriate cables for grid connection.
 For the appropriate functioning of this inverter, please use adapted cables cross- section (taking
into account the length of cables, the mode of installation, the impedances, currents and voltage).
 The recommended installation position (vertical) is to be adhered to.
 Installation must be adapted to the weight and the dimensions of the inverter.
 This inverter is designed with IP20 for indoor applications only.

3.2 Recommended equipment

This section does not specify the necessary protective equipment for the installation and for the
operator himself (electrical, thermal ...). The qualification of the worker and the protective equipment
must comply with the applicable standards and regulations.
Standard tools can be used for the installation of the IMEON. The following equipments are those
recommended for installation:
 Mounting unit:
o
A drill,
o
6 screws (IMEON 3.6 : 5 to 9 mm ØM5, IMEON 9.12 : 15 to 18 mm ØM10).
 Smart Meter installation :
o
A wire stripper,
o
An Ethernet cable,
o
A flat screwdriver Ø2mm.
 Connection to the grid, to solar, to battery, to AC Backup :
o
A wire stripper,
o
A cable cutter,
o
A crimping pliers for PV cables,
o
A crimping pliers for battery cables,
o
A set of flat and cruciform screwdrivers,
o
A multimeter.
 In case of communication via Ethernet:
o
An Ethernet cable,
Manuel d'installation / Installation guide IMEON Inverter/ Guia de montaje – Rev C.14
FR
FR
EN
ES
63