JVC KD-NX10 Manuel D'instructions page 206

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation/Connection Manual
Unit rotation corresponds to horizontal rotation. A positive val-
ue means rotation of the front of the unit towards the driver
(LHD).
The unit inclination can now be selected in degrees by turning the right
rotary control
and pressing to confirm.
Unit inclination corresponds to vertical inclination. A positive
value means upward inclination of the front of the unit.
The number of wheel impulses per wheel revolution (if known) can then
be selected by turning the right rotary control
firm.
If the number of wheel impulses per wheel revolution is not
known,
UNKNOWN
enter tyre data.
The previously entered data is displayed once more. If the data entered
is correct, press the right rotary control
If correction is necessary, select
control
and press to confirm. The values can then be re-entered.
Once the previously entered data has been confirmed, the tyre data can
be entered or self-calibration can be started.
To enter the tyre data, select
right rotary control
204
and pressing to con-
must be selected. It is then not possible to
.
by turning the right rotary
MODIFY
INPUT TYRE VALUES
and press to confirm.
by turning the

Publicité

Table des Matières
loading

Table des Matières