Entering A Destination - JVC KD-NX10 Manuel D'instructions

Entering a destination

The last location entered is displayed.
If you wish to select a destination within
the displayed location, immediately se-
lect ROAD or CENTRE .
If your destination is located else-
where, select the place using the right
rotary control and press to confirm.
Select the letters one after another by
turning the right rotary control
press to confirm. The selected letter
appears enlarged at the right of the dis-
play.
Use multifunction button
the last confirmed letter.
The complete entry can be deleted by
pressing multifunction button
more than 2 seconds.
Already entered letters are displayed in-
versely. For the purpose of support, the
name of the location closest to the previ-
ous entry is displayed. The unit offers
only the possible remaining letters for
selection. If no other entries are availa-
ble, the unit completes the place name
automatically.
To accept the entry, press and hold the
right rotary control
and
2 seconds or select the small tick
and briefly press the right rotary
control .
to delete
Navigation operation
If the complete location name has been
entered or completed automatically; i.e.
for
the location entered exists only once in
the country of destination, the unit will
switch automatically to either the place
selection list or the Road/ Centre entry.
If there are no roads or only the centre is
available for a particular town, the unit
will switch directly to the Route menu.
If an incomplete location entry was con-
firmed, the location selection list is dis-
played.
The location name most similar to the
for more than
entry appears in capital letters in the lo-
cation selection list.
The scroll marks indicate that other loca-
tions, sorted in alphabetical order, can be
selected.
A selection can be made by turning the
right rotary control
confirm. (See "General notes" on
page 118.)
and pressing to
121