Deleting A Destination From The; Destination Memory; Destination Memory Full; Route Guidance Calculation - JVC KD-NX10 Manuel D'instructions

Deleting a destination from the

destination memory

Select destination memory
page 139).
Select the destination to be deleted
with the right rotary control
press the multifunction button

Destination memory full

Appears when the destination memory is
full and if no other destinations can be
saved.
The destination memory is opened by
pressing the right rotary control. Desti-
nations can then be deleted from the des-
tination memory, as described above, to
make space for the new entry to be
saved.
The save is interrupted by pressing the
button.

Route guidance calculation

(see
The message "Calculating route" indi-
cates that the distance is being calculat-
ed; this may take several seconds.
After the first route guidance announce-
ment, the prompt CD
and flash on the display until the route is
. completely calculated. When a distant
destination is entered, it is recommend
that you wait until CD
ing before departing.

Recalculating route

If the current route is not followed due to
road blocks, diversions, unintentionally
driving in the wrong direction or failing
to observe the recommendations, the
system immediately calculates a new
route. During this re-calculation,
ROUTE is displayed.

Stopover

Stopover offers the possibility of enter-
ing a stopover destination during the ac-
tive route guidance.

Entering a stopover

will continue to
Press the
has stopped flash-
Using the right rotary control
make a selection and press the control
to confirm.
• DEST. MEMORY
(see page 139) Selecting a stopover
from the destination memory.
• DESTINATION
(see page 120) allows the entry of a
stopover with the precise specification
of the address.
NEW
Navigation operation
multifunction button.
129
,