JVC KD-NX10 Manuel D'instructions page 208

Installation/Connection Manual
Status of the calibration journey (
In the Service Mode, select
ry control and press to confirm.
The calibration status (i.e.
(i.e. 3D ) are displayed. After calibration is completed, instead of
WHEEL and REV. , the road currently being driven on is displayed (pro-
vided it is included in the digital map).
Testing the system components (
A test program automatically tests the internal components of the navi-
gation system.
In the Service Mode, select
control and press to confirm.
If is displayed, press the
OK
the Service Mode.
Function test of the GAL signal, reverse signal, unit-internal sen-
sors ( SENSORS )
• In the Service Mode, select
control and press to confirm.
• Move the vehicle several metres forwards or backwards for the
GAL signal function test.
The number value after
speed).
The number value after
vehicle is in neutral or when the accelerator is pressed while the
vehicle is parked.
206
CALIBRATION RIDE
CALIBRATION RIDE with the right rota-
STATUS: 2 ) and the type of positioning
MODULE TEST )
with the right rotary
MODULE TEST
button. The unit switches back to
SENSORS with the right rotary
WHEEL must increase (also at low
WHEEL should not increase when the
)