Replace The Strap - Hillrom Yellofins Apex Mode D'emploi

INSTRUCTIONS FOR USE
5. Replace the strap if it is damaged or can not be correctly secured to the stirrup boot.
See "Replace the Strap" on page 30.
Stirrup Pad:
1. Remove each stirrup pad. See "Remove the Stirrup Pad" on page 32.
2. Inspect each pad surface and seams for damage.
3. Make sure that fluids can not contact the foam padding inside the stirrup pad.
4. Install each stirrup pad. See "Install the Stirrup Pad" on page 32.
5. Make sure that the stirrup pad can be properly secured to the stirrup boot.
6. Replace the stirrup pad if it is damaged or can not be correctly secured to the stirrup
boot. See "Replace the Stirrup Pad" on page 32.
Overall Condition:
1. Remove each stirrup pad. See "Remove the Stirrup Pad" on page 32.
2. Inspect each stirrup boot for damage.
3. Inspect each component of the Yellofins Apexsupport tube for damage or
corrosion.
4. Inspect each gas piston for damage.
3.6.3

Replace the Strap

Remove the Strap:
1. Push the formed button towards the pad and pull the strap
away from the stirrup boot.
2. Pull the strap out of the stirrup boot.
Document Number: 80025141
Version G
Page 32
Issue Date: 26 November 2020
Ref Blank Template: 80025117 Ver. F