Operation On The Machine; Door Microswitch (Fig. 3); Product Loading Procedure Food Zone (Fig. 4) - FAS International Spirali HDR Mode D'emploi

14
8.1

DOOR MICROSWITCH (FIG. 3)

There are two microswitches A fig.3 on the electric panel protected against the fortuitous operations and
which can be operated only through the proper equipment key.
The higher microswitch, which is in accordance to the rules, is used to switch off the feeding from all the
electric parts of the machine when the door is opened. If necessary the feeding can be restored by inserting
the proper key.
The lower microswitch signals to the machine that the door is open. The message "door open machine
under maintenance" appears on the display. The ventilation and the refrigeration unit will be switched off. In
this condition the vend cycle is inhibited and access is only available for programming and machine testing.
Normal machine operation may be restored by inserting the proper key.
"REMOVE THE KEY FROM THE ELECTRIC PANEL BEFORE CLOSING THE DOOR".
E
N
G
L
I
S
H
8.2

PRODUCT LOADING PROCEDURE FOOD ZONE (FIG. 4)

Once the installation procedure and the programming of the machine have been done, proceed as follows:
1) Open the machine door.
2) Take out one tray each time and pulling outward till you reach the stop. The tray will tilt downward
making the loading easier.
3) Start the loading from front to rear and make sure that all spaces are loaded. The bottom of the product
should be placed on the base of the division right above the spiral, with label turned to the window so
that it is recognizable by the customer. All products have to be easily placed in the spirals; do not
introduce bigger objects. Spirals can have different pitches and therefore you should choose the spiral
suitable for the product you want to vend or vice-versa choose the product according to the spirals you
have.
4) After having loaded all trays, make sure that they turn to position "STANBY". They must be pushed to
the inner side of the cabinet. Each spiral can be turned each time of 45°. Most of the products can be
sold without troubles when the spiral end is positioned at hour 6. For brik products adjust the end 90° in
advance.
NOTE: Products in bags or boxes must be correctly placed. The sealed edge of the bag can slip under the
spiral wire not allowing the fall of the bag. It is recommended to fold the edge forward and upward before
inserting the bag in the space of the spiral.
Products like cakes, biscuits, "handle with care" objects, etc., should be placed in the lower trays so that they
will not be damaged falling.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
8

OPERATION ON THE MACHINE

Fig. 3
Spirali HDR Panzer - Issue 00