To Set Machine Parameters - FAS International Spirali HDR Mode D'emploi

Spirali HDR Panzer - Issue 00
9.2.3

TO SET MACHINE PARAMETERS

Command 50 Sets machine type:
This command is used to select the type of machine. The choice is EVEREST and HDR. If the command is
set at 1, the model chosen is the EVEREST. If the command is set at 0, the model chosen is HDR. For
default, 1 is set.
The setting of the command MUST BE consistent with the type of machine,
otherwise the machine will not function
Command 53 Enable photocells:
Upon access to this command select the type of photocells installed on the vending machine: choose
between "barrier photocell" (double transmission/reception board), or "reflector photocell" (one board with
reflector); scroll the two options using any button on the panel and confirm by pressing the "B" button. Then
set the parameter at 0=to disable or 1=to enable the device. If the parameter is set at 1, access is obtained
to the menu for disabling the required selections (dispensing without photocell control). To disable one or
more selections, simply type the number of the selection and then set the value at zero.
Command 54 Photocell test (REFLEX):
This command is used to test that the photocells are functioning correctly. A test procedure is started
automatically, then at the end of the procedure, if there are no problems a single value appears which
corresponds to the magnitude of the incoming signal. If there is a problem with the functioning, a second
value appears on the display which refers to the problem. See the table for Command 99 for this second
value.
Command 55 Setting the operating parameters of the photocell barrier (REFLEX) :
This command allows the operator to view and change the operating parameter of the photocell barrier.
Message Default value
"Hyster.HL" 6
Command 56 System's operating options ("FTC Options " REFLEX) :
Setting this command determines how the machine will react if the product is not delivered. The value can
be set at between 0 and 3. Default = 0.
The meaning of the setting is as follows:
0 = Possibility of another selection; in this case command 63 (single-multisale) must be set at 1 (if it is an
executive payment system the multisale must also be set in the payment system).***
1 = Automatic credit delivery; in this case command 63 must be set at 0 (if it is an executive payment system
the single sale must also be set in the payment system).***
2 = Further quarter turn: if the product is not delivered the spiral completes a further 1/4 turn and if the
product has still not been delivered then the machine reverts to one of the preceding two options depending
on the single or multisale parameter that has been set.
This option is not applicable to the ½ turn spirals which must consequently be disabled. In order to do this,
set the value 2 on command 56 to automatically enter the menu which permits the option for the individual
spirals to be disabled/enabled. To disable the option relevant to a spiral simply key in the number of the
selection and set the value at 0. Inversely by setting a value of 1 the option is enabled. If the payment
system uses the Executive protocol, the single-multisale must also be set on the payment system.***
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
Meaning
This parameter acts on the sensitivity of the reading of the system.
The lower the value set in this parameter , the greater the
sensitivity of the system. The value can vary from a minimum of 5
to a maximum of 30.
21
E
N
G
L
I
S
H