Adjustments; Spirals (Fig. 6); Procedure For Replacing The Spirals And The Expeller Motor Gr. (Fig. 7) - FAS International Spirali HDR Mode D'emploi

34

10.1 SPIRALS (FIG. 6)

E
N
G
L
I
S
H

10.2 PROCEDURE FOR REPLACING THE SPIRALS AND THE EXPELLER MOTOR GR. (FIG. 7)

FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it

10 ADJUSTMENTS

Most of the products can be sold without problems when the end of the spiral is
placed on hour 6.To modify the end, draw the spiral forward until the base of the spiral
support will come out from the pit; then turn the spiral in the wished position and put it
again into the pit.
Each spiral can be turned each time of 45°.
The machine is supplied with trays with spirals of different diameters and pitches.
To vary their quantity or their order, proceed as follows:
1) Open the main door.
2) Pull out the tray on which you have to vary the spiral.
3) Switch off and take out the group motor-spiral.
4) Take out the spiral from the plastic support (lever between spiral and support) and
replace with the other spiral or with the other expeller motor group.
5) Fit up the new spiral group reversing the above operations. After having finished
this operation, make sure that the end of the spiral is put on hour 6, otherwise see
paragraph 9.1.
Fig. 6
Fig. 7
Spirali HDR Panzer - Issue 00