Procedure For Removing The Trays (Fig. 8- Fig. 9); To Alter The Number Of Trays (Fig. 9) - FAS International Spirali HDR Mode D'emploi

Spirali HDR Panzer - Issue 00

10.3 PROCEDURE FOR REMOVING THE TRAYS (FIG. 8- FIG. 9)

To remove the tray, proceed as follows:
1) Open the main door.
2) Switch off placing the main switch in position "off".
3) Disconnect the electric connector -A- Fig. 9.
4) Remove the tray by forcing the clamp of the positioning spring.
5) Pull the tray till the stop, lift it upwards, then rotate it downwards till the guide
unhooks. Remove it from the machine Fig. 8.
To mount another tray proceed as follows:
1) Insert the tray.
2) Push till the tray sets itself into clamping position.
3) Insert the electric connector -A- Fig. 9.
4) Put the machine on by positioning the switch to "on".
5) Close the main door.
Fig. 8

10.4 TO ALTER THE NUMBER OF TRAYS (FIG. 9)

The number of trays of the machines supplied with 6 trays can be changed.
To change from 6 to 7 trays proceed as follows:
1) Open the main door.
2) Switch off placing the main switch in position "off".
3) Take out all the trays.
4) Displace the guides ref. B Fig. 9(the last from the bottom is already in the right
position and is therefore not to displace).
5) Displace the connectors, ref. A Fig. 9, placed on the edge of the cabinet.
6) Remove a pair of guides and a connector wiring.
7) Re-assemble 7 trays checking that the clamping spring is engaged and the
connectors well inserted.
8) Set the new prices.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
Fig. 9
35
E
N
G
L
I
S
H