Programming Procedure - FAS International Spirali HDR Mode D'emploi

16
When the machine is switched on for the first time the message "INIT" and then "memory cleared" will
appear on the display. This message indicates that the memory has no stored data or that the data in
memory are corrupted. The machine is in the same condition as it is after the "erase memory" command has
been executed or the memory has failed.
Pressing the push-button test (Fig. 5) mounted on the card inside the coin mechanism, the memory will be
automatically reset to its pre-defined values listed in the programming instructions.
When the microswitch of the door is closed (Fig. 3 ref.A) the machine will start a self-configuration
procedure that consist in checking the No. of spirals in every tray. In this phase the message TEST 12 will
appear for some seconds on the display and after this the machine can be put into service.
E
N
G
L
I
S
TEMPERATURE
PROBE
H
PAYMENT SYSTEM
MDB
PAYMENT SYSTEM
EXECUTIVE
It is also possible to carry out a function test of the machine by pressing the pushbutton test (Fig. 5) placed
on the main card. The message "SELECTIONS OK" will appear on the display. As an alternative an
indication (ex. 12, 14...) could appear to indicate that an irregularity has taken place during the functioning
and the spirals indicated are out of service. Carry out the selection shown on the display to reset. If a
working mistake happens during the test, the tag of the spiral or module will stay on the display; otherwise
the test will go on to the next out-of-work spiral. If all the selections are all right the corresponding message
will appear on the display. It is possible to test all the selections typing in the corresponding tag. After having
finished the test press again the push-button test on the main card to go back to normal working.
N.B.: To avoid errors the machine returns automatically to normal work after about 1 minute from the
access to test mode, during which no operation is carried out.
If during the test or the reset there should happen some errors, it means that the anomaly is not occasional
but could result from the breakage of some parts and a technical intervention is required.
After having completed the installation procedure, open the door of the coin mechanism compartment fig. 2
and keep the test switch pressed for about 3 seconds until the buzzer gives a prolonged sound. This
indicates that the machine is in programming mode and the message Command 00 appear on the display.
Attention: if the button is released before time the machine will enter "check selections" mode described
above. To exit this mode press again the button and then repeat the process to enter in programming mode.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
9

PROGRAMMING PROCEDURE

If the machine becomes blocked in TEST 11, enter programming and check that
the setting of command 50 is consistent with the model of the machine
RS232
PUSHBUTTON
TEST/PROGR./DATA
SENDING
Fig. 5
Spirali HDR Panzer - Issue 00
CONNECTION
POWER
INTERFACE