Operation On The Machine; Door Microswitch; Product Loading Procedure; Vending A Product - FAS International 480 ELE Mode D'emploi

10
6.1 DOOR MICROSWITCH (fig.3)
On the left low reinforcement there is a microswitch ref.A fig.3 protected against accidental
operations that can be driven only through the special spanner in equipment.
The microswitch, which complies with the regulations, is used to disconnect all electrical parts of
the machine when the door is opened. If necessary ithe feeding can be restored inserting the
special key.

6.2 PRODUCT LOADING PROCEDURE

Once the machine has been commissioned, proceed as follows:
1) Open the main door.
2) Disconnect the solenoids and unhook the pistons corresponding to the drums which will be free
to rotate during the loading procedure.
3) Rotate the drums by hand.
4) After the loading make sure that the empty compartment of every drum is in front of the delivery
door.
N.B. Make sure the products are not coming out from the edges of the drum itself.

6.3 VENDING A PRODUCT

After loading according to instructions in paragraph 6.2, setting the selling prices for each
product, filling the change tubes (if the machine is equipped with a change giving coin mechanism
), the machine is ready to vend.
1) Insert the correct amount for the purchase.
2) Press the selection pushbutton corresponding to the chosen product.
3) Take the product from the compartment which has been automatically opened.
FAS INTERNATIONAL srl

6 - OPERATION ON THE MACHINE

fig. C