Figure 3.10: User Screen - Avocent AMX Switch Serie Guide D'installation

42 AMX Switch Series Installer/User Guide
Once scanning is initiated, the AMX switch will cycle through the selected target devices in
alphabetical order.
If the user has full access rights to the current target device and the AMX user station detects
keyboard or mouse activity, scanning is suspended. This allows the user to work with the target
device. When mouse and keyboard activity stops, scanning resumes with the next channel in
sequence. If the user has view only access rights to the current target device, scanning will not be
suspended if the user types on the keyboard or moves the mouse.
Dwell time, the length of time each server channel remains on screen, is configurable and can be
changed at any time through the User tab. Default dwell time is three seconds.
To stop scanning the switching system:
1. Press
Ctrl+Ctrl.
2. Click the Stop button.
3. Click Close or X to exit the OSCAR interface.
To change the scan dwell time:
NOTE: If the lockdown mode is on, none of the fields in this screen will be active, with the exception of the log
out button.
1. Press
Ctrl+Ctrl
2. Click the User tab.

Figure 3.10: User Screen

3. Change the scan dwell time, designated in seconds, by typing a number between 3 and 99.
To save changes, click Apply. To exit the OSCAR interface, click Cancel or X.
4.
The Target tab screen redisplays.
to launch the OSCAR interface.