Accessing The Command Line; Resetting The Keyboard And Mouse; Figure 3.30: Configure Screen; Table 3.5: Osd Command Line Hotkey Sequences - Avocent AMX Switch Serie Guide D'installation

62 AMX Switch Series Installer/User Guide

Accessing the Command Line

Table 4.3 provides a list of hotkey sequences used to activate the Command Line. The default
Command Line hotkey sequence is the
key. You can set the following hotkey sequences from the list available on the Console tab.

Table 3.5: OSD Command Line Hotkey Sequences

Sequence
NumLock + "-"
NumLock + "/"
NumLock + "+"
NumLock + "*"
To change the OSCAR interface command line sequence:
1. Press
Ctrl+Ctrl
2. Click the Console tab, then click the down arrow button to display the Configure screen.

Figure 3.30: Configure Screen

3. Click the Cmd Line drop-down menu and select a command line.
4. To save changes, click Apply. The selected sequence changes from black to blue text. To exit
the OSCAR interface, click Cancel or X.

Resetting the keyboard and mouse

Should you lose keyboard and mouse connectivity, you can use the Command Line to quickly
restore default settings for the keyboard and mouse attached to the user station you are currently
logged in to.
NumLock
Keystroke Description
NumLock key, pressed and held, followed by the Minus (-) key
NumLock key, pressed and held, followed by the Slash (/) key
NumLock key, pressed and held, followed by the Plus (+) key
NumLock key, pressed and held, followed by the Asterisk (*) key
to launch the OSCAR interface.
key pressed and held, followed by the (-)
Minus