Avocent AMX Switch Serie Guide D'installation page 113

Table F.1: Access Commands (Continued)
Command Function
Enables persistent connection mode on a user station. Every time a connection is
made to a server, the UID of the server and the connection type are stored in
enable persistent mode
EEPROM. If the connection is lost, these values are used to re-establish the
connection.
Disables persistent connection mode. If a connection is lost, there will be no attempt
disable persistent mode
to try to re-establish it.
Shows the current persistent connection mode, and if enabled, shows the current
show persistent mode
stored UID and connection type settings.
Enables VCM Once mode. This will cause VCM settings for the next connection to
vcm once (remove vcm be stored in EEPROM and used in all subsequent connections. If this command is
blink) executed when VCM is already in this mode, the VCM settings of the next
connection established will replace the existing VCM settings in EEPROM.
Disables VCM Once mode and returns the AMX 51xx switch to its normal VCM
vcm always
mode, where VCM is performed on every connection established.
Shows the current VCM mode and displays the VCM settings currently stored in
vcm status
EEPROM.
Clears the currently stored username and password that are stored if the Auto Login
disable auto user login
feature is enabled.
enable pod switch
Enables this mode. This cannot be done via the OSD if a switch is not connected.
mode
disable pod switch
Disables this mode. This cannot be done via the OSD if a switch is not connected.
mode
Shows the current status of this mode. This cannot be done via the OSD if a switch is
show pod switch mode
not connected.
When serial emulation is enabled, the CPU's serial port is disabled (AMX 5130
enable serial emulation
switch user station only).
When serial emulation is disabled, the CPU's serial port is enabled (AMX 5130
disable serial emulation
switch user station only).
equalization tuning Shows the Equalization Tuning OSD.
Shows the Deskew Tuning OSD (Only on AMX 5121/5130 switch - based platforms
deskew tuning
with skew card).
enable serial force Enables this mode. Can also be performed via OSD Lockdown Tab, but must be
mode performed via command line if only local AMIQ modules are connected.
disable serial force Disables this mode. Can also be performed via OSD Lockdown Tab, but must be
mode performed via command line if only local AMIQ modules are connected.
Appendices 101