Appendix F: Command Functions; Table F.1: Access Commands - Avocent AMX Switch Serie Guide D'installation

100 AMX Switch Series Installer/User Guide

Appendix F: Command Functions

Table F.1: Access Commands

Command
bl
print sys info
set def res 0
set def res 1
do vcm
rev hw
rev osd
rev dl
rev fw
unit uid
sys info
rm
rk
rev fw
rev dl
ddctable '[servername]'
xxxxx
fc '[userstationname]
''[servername] '
fd '[userstationname]
Function
Calls Bootloader.
Prints system info and debug info to the serial port.
Sets default OSD resolution to low (640 x 480).
Sest default OSD resolution to high (1024 x 768).
Performs VCM.
Prints hardware revision to the serial port.
Prints OSD revision to the serial port.
Prints datalink revision to the serial port.
Prints firmware revision to the serial port.
Prints UID to the serial port.
Prints sys info to the serial port.
Resets mouse.
Resets keyboard.
Displays firmware revision to the serial port.
Displays datalink revision to the serial port.
Configures the connected AMIQ module with matching "servername" to use the
DDC table stored in the AMIQ module.
Options are:
• ddctable 'server234' default (use the default ddc table)
• ddctable 'server234' nVidia (use the nVidia ddc table)
• ddctable 'server234' disable (don't use any ddc table)
If configured correctly, you will see an OSD message stating the AMIQ module's
current configuration. To configure an AMIQ module, it must be available on the
Target List.
Forces connection of [userstationname] to [servername].
Names are case sensitive. Use single quotes.
Forces disconnection on [userstationname] .
Names are case sensitive. Use single quotes.