Setting A Local Switch Hotkey; Figure 3.4: Configure Screen; Figure 3.5: Configure Screen - Avocent AMX Switch Serie Guide D'installation

38 AMX Switch Series Installer/User Guide

Figure 3.4: Configure Screen

Select Quick Switch.
3.
To save changes, click Apply. To exit the OSCAR interface, click Cancel or X.
4.
NOTE: Quick switch hotkeys only work if there is an existing connection and the OSCAR interface is
not activated.

Setting a local switch hotkey

A local switch hotkey allows you to force a connection to the local server by typing

Figure 3.5: Configure Screen

To enable the local switch hotkey:
1. Press
Ctrl+Ctrl
2. Click the Console tab, then click the down arrow button to display the Configure screen.
Select Local Switch.
3.
To save changes, click Apply. To exit the OSCAR interface, click Cancel or X.
4.
NOTE: The local switch hotkey will not force a connection if two local servers are attached to the user station or
if the OSCAR interface is open when the hotkey is entered.
to launch the OSCAR interface.
.
Alt+2