Chapter 1: Installation; Installation; Rack Mounting Your Integrated Lcd Kvm Switch - Avocent LCD17SWT8 Guide D'installation

CAUTION: To reduce the risk of electric shock or damage to your equipment:
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at
all times.
- Disconnect the power from the unit by unplugging the power cord from either the
electrical outlet or the unit.

Rack Mounting Your Integrated LCD KVM Switch

Your Integrated LCD KVM Switch may be rack mounted using brackets.
Before installing the switch, stabilize the rack in a permanent location.
Be sure to rack your Integrated LCD KVM Switch in an area of the
cabinet that will allow you to utilize the LCD monitor, keyboard and
mouse funtions.
CAUTION: Rack Loading - Overloading or uneven loading of racks may result in
shelf or rack failure, causing damage to equipment and possible personal injury.
Do not exceed your rack load rating.
To mount the Integrated LCD KVM Switch:
1. Loosen the four rear screws of each mounting bracket without
completely removing the screws. You will have to extend the
bracket to access two of the screws on the bracket.
NOTE: Mounting brackets are labeled with an "L" for the left-side bracket and an
"R" for the right-side bracket.
2. Using the M4 screws provided, connect both left and right brackets
to the cabinet frame. After securing the brackets to the cabinet,
tighten the four rear screws loosened in step 1.
Figure 1.2: Installing the Integrated LCD KVM Switch to a Cabinet
3. Align the rear of the Integrated LCD KVM Switch with attached
brackets and slide the unit into the front of the cabinet.

Chapter 1: Installation

3