Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
Integrated LCD KVM Switch Installer/User Guide
Installation
If you are installing your Integrated LCD KVM Switch to a PS/2
interface, you must turn off all servers before connecting your appliance
to a server for proper installation. USB interfaces do not need to be
turned off before installation.
NOTE: Linux users may experience mouse failure if hot-plugging directly to the
Integrated LCD KVM Switch. If your mouse becomes locked, use the mouse reset
hotkeys (see Appendix A ) to reset your mouse, or turn the Linux server off before
connecting it to the Integrated LCD KVM Switch.
To install the Integrated LCD KVM Switch:
1.
Plug one end of the supplied power cord into the back of the switch
and the other end into an appropriate power source.
2.
Connect your servers to an available port on the rear of your
Integrated LCD KVM Switch using the appropriate cable.
3.
Turn on all connected servers. Keyboard and mouse recognition is
now activated and your Integrated LCD KVM Switch is ready for
operation. Figure 1.1 shows a basic configuration for the 16-port
Integrated LCD KVM Switch.
1
Figure 1.1: Basic 16-Port Integrated LCD KVM Switch Server Configuration
Table 1.1: Description of Figure 1.1
Number
1
2
3
4
2
3
Description
USB Ports
Daisy-chain Ports
Power
Server
4
Publicité
Chapitres
Table des Matières
