Forcing A Connection Using Snmp; Table 3.7: Force Disconnect Confirmation Codes - Avocent AMX Switch Serie Guide D'installation

Table 3.7: Force Disconnect Confirmation Codes

Code
0
1
4

Forcing a connection using SNMP

To force a connection using SNMP, the access rights that apply to SNMP control are assigned to a
user named "snmpUser." After adding and setting access rights for the snmpUser, you can force a
switch to any of the target devices to which the snmpUser has access.
For instructions on adding an SNMP user, see the AMWorks software online help program. For
more information on forcing an external switch on the AMX switch, refer to the specific MIB file
called AMX-MIB. This MIB file is available on the AMWorks software CD. You can also
download the AMX-MIB file by visiting www.avocent.com/support and clicking
Product Upgrades.
Definition
The command was valid. The connection to the target device was terminated.
Invalid syntax. The command was not entered correctly.
An invalid command was entered.
Chapter 3: Operations 69