Avocent AMX Switch Serie Guide D'installation page 99

4. Repeat steps 2 and 3 to modify additional values.
5. Press to save your changes and exit the Configuration Screen.
Enter
- or -
Press to exit the Configuration Screen without saving the changes.
Esc
Creating an AMIQ-SRL module macro
Pressing the Page Down key when the Configuration Screen is displayed will provide access to the
Macro Configuration screen. The AMIQ-SRL module can be configured with up to 10 macros.
Each macro can be up to 128 characters in length.
To create a macro:
1. Select the AMIQ-SRL module you wish to configure and press
Configuration Screen.
2. When the Configuration Screen appears, press
The Macro Configuration screen shows the 10 available macros and the associated key
sequences, if any, for each.
3. Using the
Up Arrow
the listed keystroke sequence. Type the new macro keystroke sequence over the default. Any
combination of
Ctrl
keystroke sequence that will activate the new macro, press the
4. On the line below the macro keystroke sequence you just entered, type the keystroke sequence
that you wish the macro to perform.
5. Repeat steps 3 and 4 to configure additional macros.
6. When finished, press
- or -
Press to exit the Macro Configuration screen without saving the changes.
Esc
Using History mode
History mode allows you to examine the contents of the history buffer, which contains the events
that have occurred.
The AMIQ-SRL module maintains a buffer containing 240 lines minimum, or 10 screens, of
output. When the history buffer is full, it will add new lines at the bottom of the buffer and delete
the oldest lines at the top of the buffer.
NOTE: The Config Key Sequence, On-Line Key Sequence and Clear History Key Sequence used in the
following procedure are the default values. These key combinations can be changed using the
Configuration Screen.
Page Down
and keys, scroll to an available macro number and highlight
Down Arrow
or and a single key may be used. When you have finished entering the
Alt
to save your changes and exit the Macro Configuration screen.
Enter
Appendices
to activate the
Ctrl-F8
to view the Macro Configuration screen.
key.
Down Arrow
87