Avocent AMX Switch Serie Guide D'installation page 114

102 AMX Switch Series Installer/User Guide
Table F.1: Access Commands (Continued)
Command
enable rerequest pod
disable rerequest pod
vcm sdb on
vcm sdb off
vcm cu
vcm cd
vcm rcu
vcm rcd
vcm gcu
vcm gcd
vcm bcu
vcm bcd
vcm reset
sk off
sk apply
Function
Enables this mode. The user station will then attempt to request the pod channel if it
has been connected to a target and does not have the pod channel. The user station
will make one request approximately every 10 seconds. The request will only be
successful if the pod channel has been unused for the previous second.
Disables this mode. This cannot be done via the OSD if no switch is connected.
Turns On VCM Config access.
NOTE: Turning on VCM Config access must be done before using the commands
below. The default setting is Off.
Turns off VCM Config access.
Tunes VCM (all three: red, green and blue) up 1 (setting is applied to current
connection only).
Tunes VCM down 1.
Tunes red VCM up 1.
Tunes red VCM down 1.
Tunes green VCM up 1.
Tunes green VCM down 1.
Tunes blue VCM up 1.
Tunes blue VCM down 1.
Resets VCM.
Turns skew off.
Applies skew.