Table 1.10: History Mode Control Keys; Table 1.11: Amiq-Srl Module Pinouts - Avocent AMX Switch Serie Guide D'installation

88 AMX Switch Series Installer/User Guide
To use History mode:
1. Press
Ctrl-F9
2. Press each key to perform the action described in the following table.

Table 1.10: History Mode Control Keys

History Mode
Home
End
Page Up
Page Down
Up Arrow
Down Arrow
CTRL-F
CTRL-F11
3. When finished, press
AMIQ-SRL module pinouts
The AMIQ-SRL module pinouts are provided in the following table.

Table 1.11: AMIQ-SRL Module Pinouts

DB9-F
1
2
3
4
5
6
7
. The mode will display as History.
Action
Move to the top of the buffer.
Move to the bottom of the buffer.
Move up one buffer page.
Move down one buffer page.
Move up one buffer line.
Move down one buffer line.
Enters Configuration mode. The Configuration Screen will display. Press Ctrl-F9 to
return to the previous screen with History mode enabled or Ctrl-F10 to return to the
previous screen with On-Line mode enabled.
Clears the history buffer. If you choose this option, a warning screen will appear.
Press Enter to delete the history buffer or Esc to cancel the action. The previous
screen will redisplay.
to exit History mode and return to On-Line mode.
Ctrl-F10
Host Signal
Name/Description
DCD- Data Carrier Detect
RXD - Receive Data
TXD - Transmit Data
DTR - Data Terminal Ready In to SRL
GND - Signal Ground
DSR - Data Set Ready
RTS - Request to Send
Signal Flow SRL Signal Name/Description
Out of SRL DTR - Data Terminal Ready
Out of SRL TXD - Transmit Data
In to SRL RXD - Receive Data
DSR - Data Set Ready
N/A GND - Signal Ground
Out of SRL DTR - Data Terminal Ready
In to SRL CTS - Clear to Send