Figure 3.10: Security Dialog Box - Avocent AutoView 2000 Guide D'installation Et D'utilisation

24 AutoView 2000 Installer/User Guide

Figure 3.10: Security Dialog Box

To set or change the password:
1. Single-click and press
2. Type the new password in the New text box and press
Passwords must contain both alpha and numeric characters, are case sensitive and may be up to
12 characters long. Legal characters are: A to Z, a to z, Ø to 9, space and hyphen.
3. In the Repeat box, type the password again and press
4. Click OK to change only your password, and then close the dialog box.
NOTE: If you should lose or forget your password, please contact Avocent Technical Support about returning
your switch for service. See Appendix C:Technical Support for contact information.
To password protect your console:
1. Set your password as described in the previous procedure.
2. Select Enable Screen Saver.
3. Type the number of minutes for Inactivity Time (from 1 to 99) to delay activation of password
protection and the screen saver feature.
4. For Mode, select Energy if your monitor is E
CAUTION: Monitor damage can result from the use of Energy mode with monitors not compliant with
E S ®.
NERGY TAR
5. (Optional) Click Test to activate the screen saver test which lasts 10 seconds then returns you
to the Security dialog box.
6. Click OK.
To log in to your console:
1. Press any key or move the mouse.
or double-click in the New text box.
Enter
NERGY
.
Enter
.
Enter
TAR ®
S compliant; otherwise select Screen.