Figure 3.16: Diagnostics Dialog Box; Table 3.5: Diagnostic Test Details - Avocent AutoView 2000 Guide D'installation Et D'utilisation

30 AutoView 2000 Installer/User Guide

Figure 3.16: Diagnostics Dialog Box

Next to each item to be tested, you will see a pass (green circle) or fail (red x) symbol display to
the left of each item as that test finishes. The following table details each of the tests.

Table 3.5: Diagnostic Test Details

Test
Memory Tests
Firmware CRCs
Comm Interfaces
Switch Controller test
Local Video
On-line AVRIQ modules
Offline AVRIQ modules
Suspect AVRIQ modules
To run diagnostic tests:
1. If the OSCAR interface is not open, press
2. Click Commands
be disconnected.
Description
Reports on the condition of the main board RAM
Reports on the condition of the main board RAM
Validates the current firmware images stored in the system's FLASH
Verifies the switch matrix controller is accessible and functional
Indicates the condition of the local video monitor
Indicates the total number of currently connected and powered AVRIQ modules
Indicates the number of AVRIQ modules that have been connected successfully
in the past and are powered down
Indicates the number of AVRIQ modules that have been detected, but are either
unavailable for connection or have dropped packets during the ping tests
Run Diagnostics. A warning message displays indicating that all users will
-
. The Main dialog box will appear.
Print Screen