Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To configure SNMP processing:
1.
On the Serial Console Main Menu, press
Configuration Menu displays.
2.
Press
and
1
Enter
3.
Press
and
2
Enter
name and
.
Enter
4.
Press
and
3
Enter
community name and press
5.
Press
and
4
Enter
press
.
Enter
NOTE: The read, write and trap community names must match those used by the SNMP Browser/Trap Logger.
6.
Press
,
,
,
and
5
6
7
8
want to send SNMP traps. Type each trap IP address and press
NOTE: The trap destination address must take the format of a decimal IP address as follows: xxx.xxx.xxx.xxx
7.
Press
and
9
Enter
SNMP trap you wish to enable or disable and
8.
Press
and
0
Enter
- or -
Press
and
x
Enter
See To add a user and Forcing an internal switch in Chapter 4 for information on adding an SNMP
user and assigning rights to the SNMP user.
Managing AMX switch objects with SNMP
Using SNMP, you can monitor and manage MIB (Management Information Base) objects specific
to the AMX5000 and AMX5010 switch. Refer to Table 5.2 for a description of the AMX system
MIB object groups.
Table 5.2: AMX System MIB Object Groups
Object Group
amxAppliance
amxAmiq
amxUserStation
amxStats
amxSnmp
to toggle the SNMP mode from Disabled to Enabled.
to specify the community to which traps will be read. Enter the community
to specify the community name to which traps will be written. Enter the
.
Enter
to specify the trap community name. Enter the trap community name and
to specify each trap IP address of up to four trap hosts to which you
Enter
to display the SNMP Trap Configuration Menu. Press the number of each
to apply and store all changes.
to restore settings as they were before changes were made.
Purpose
Provides general information about the AMX switch, including firmware and
hardware revisions
Provides a list of available AMIQ modules from the AMX5000 or AMX5010 switch
Provides a list of user stations connected to the AMX5000 or AMX5010 switch
Provides statistics on packets for each port (only available internally)
Provides information on SNMP settings.
Chapter 5: Terminal Operations
to select SNMP Configuration. The SNMP
4
Enter
.
Enter
.
47
Publicité
Chapitres
Table des Matières
