Avocent AMX Série Guide D'installation Et D'utilisation page 23

3. When the power is switched on, the Power indicator on the front of the unit will remain orange
for approximately 30 seconds while performing a self-test and then change to green. This
indicates a healthy condition.
4. Next, follow these instructions to set up the Terminal Applications menu. Refer to Chapter 5
for more details.
a. You will be prompted to enter a username. The first time you access the switch, enter the
username
admin
menu, you can configure a password should you wish to do so.
b. Once you have logged in to the AMX switch, you will see the AMX switch Console menu
with four options. Select option 1, Network Configuration. This will activate the Network
Configuration menu.
c. Within the Network Configuration menu, select option 1 to set the IP address.
d. Select options 2 and 3 to set your netmask and default gateway respectively.
e. Once these settings are entered, type
f. If all AMX switches in your installation are part of the same AMX switching system
configuration, you may leave the configuration ID set to
AMX switching system configuration within your subnet, you will need to designate the
group to which this AMX switch belongs. To do this, select option 2 to enter the
configuration ID for your AMX switch. A configuration ID will designate an AMX switch
as part of a unique installation. When change commands are issued through the AMWorks
software, only units with the same configuration ID as the AMWorks software will be
affected. Refer to System Management in Chapter 5 for more information on setting
configuration IDs.
g. Once you have entered a configuration ID, enter
h. Finally, select option 3 and follow the prompts to password protect your AMX switching
system terminal settings.
i. Press to exit the AMX switching system Console menu.
0
To make a LAN connection:
Using a UTP cable, connect the Network port on the back of the AMX switch to your LAN.
Connecting devices to the AMX switch
Once the AMX switch is installed, you can begin attaching servers or serial devices to it. All are
connected to the AMX switch through the use of AMIQ modules. For information on connecting
other KVM switches to the AMX switch, see Installing a cascaded AMX switching system later in
this chapter. See Appendix B for information on using AMIQ-SRL devices.
and press . Once you have access to the AMX switch Console
Enter
to return to the AMX switch Console menu.
0
Chapter 2: Installation
. If you are running more than one
0
to return to the main menu.
0
13