Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12
AMX Switch Series Installer/User Guide
Figure 2.4: AMX5000 Switch Rack Mounting Diagram
Figure 2.5: AMX5010 Switch Rack Mounting Diagram
To install the rack mounting bracket:
1.
Remove the two side screws closest to the front from each side of your AMX switch.
2.
Line up the holes in the brackets with the holes on the sides of the AMX switch.
3.
Using the screws supplied with the rack mounting bracket, thread one through each of the
holes in the sides of the rack mount brackets and into the AMX switch. Tighten them securely.
4.
Install the AMX switch into your rack using the approved method of your rack manufacturer.
To install a new single AMX switch:
1.
Plug the supplied power cord into the back of the AMX switch and then into an appropriate
power source.
2.
Connect a terminal or PC running terminal emulation software (such as HyperTerminal
the terminal port of the AMX switch using the supplied null modem cable. The terminal should
be set to 9600 baud, 8 bits, 1 stop bit, no parity and no flow control.
®
) to
Publicité
Chapitres
Table des Matières
