Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Attach one end of the CAT 5 cable to the RJ-45 connector on the AMIQ-SRL module. Connect
the other end of the CAT 5 cable to the desired computer port on the back of your AMX switch.
4.
Connect the power supply to the power connector on your AMIQ-SRL module. The cable
expander can be used to power up to four AMIQ-SRL modules from a single power supply.
5.
Connect the AMIQ-SRL module power supply to an appropriate AC wall outlet to power up
your serial device.
Repeat this procedure for every serial device that will be attached to your AMX switching system.
Connecting users to the AMX switching system
Once all servers are connected, you can begin to connect users. Users are connected to the AMX
switching system through the AMX user station.
AC Power
Figure 2.8: AMX5100 User Station Rear Panel
AC Power
Figure 2.9: AMX5110/5120 User Station Rear Panel
To connect users to the AMX switching system:
1.
Place the AMX user station near the monitor you wish to connect. Each unit is designed to bear
the weight of a monitor and can be used as a monitor stand.
2.
Plug your keyboard, monitor and mouse cables into the appropriate ports on the back of the
user station.
KVM
Connection to
Access
AMX Switch
Connections to AMX
KVM
Switch/Local Server
Access
Chapter 2: Installation
Serial Port
Serial Port
15
Publicité
Chapitres
Table des Matières
