Figure 3.8: Oscar Interface Target Tab - Avocent AMX Série Guide D'installation Et D'utilisation

28 AMX Switch Series Installer/User Guide
4. To disconnect from a selected server, activate the OSCAR interface and click the
Disconnect button or switch to another server.
To scan an AMX switching system:
1. Press
Ctrl+Ctrl
2. Select the Target tab and click the Scan radio button.

Figure 3.8: OSCAR Interface Target Tab

Press and hold the
Alternately, if you wish to select a group of servers in sequence, you can click the first server in the
list, press and hold the
3. Click the Start button to begin scanning.
Once scanning is initiated, the AMX switch will cycle through the selected servers in alphabetical
order. If the user has full access rights to the current server and the AMX user station detects
keyboard or mouse activity, scanning is suspended. This allows the user to work with the server.
When mouse and keyboard activity stops, scanning resumes with the next channel in sequence. If
the user has view only access rights to the current server, scanning will not be suspended if the
user types on the keyboard or moves the mouse. The length of time each server channel remains
on screen, or dwell time, is configurable and can be changed at any time through the User tab.
Default dwell time is three seconds. To halt scanning, press
4. Click the Stop button.
5. Click Close to exit the Target tab screen.
to launch the OSCAR interface.
key while you individually select the servers that you would like to scan.
Ctrl
key and select the last server to highlight the list.
Shift
The screen redisplays.
Ctrl+Ctrl.