Avocent AMX Série Guide D'installation Et D'utilisation page 53

To force a user to make or break a connection:
NOTE: The following rules apply for optimum operation of the force connection feature:
- Both the user entering the command and the user at the target user station must have rights to the server.
- All force connections are done in Shared mode.
- All user stations and AMIQ modules must have unique names.
- If the source and target user stations are connected to different AMX switches, the AMX switching system must
be synchronized using the AMWorks software.
1. Press the default Command Line hotkey sequence to display the Command Line.
2. Type
fc '[TargetUserStationName]' '[servername]'
station to connect to the specified server.
3. Type
fd '[TargetUserStationName]'
disconnect from the connected server.
NOTE: The TargetUserStationName is shown in the OSCAR interface ? tab of the target user station. After
selecting the ? tab, press the
in the AMWorks software. The servername is the name of the AMIQ module and should be entered exactly as it
displays in the target list. Single quotes are required before and after the TargetUserStationName and the
servername. The following is an example of a force connection command: fc 'User Station 3' 'Server 43'.
To configure the DDC table:
1. Press the default Command Line hotkey sequence to display the Command Line.
2. Type
ddctable '[servername]' default
specified servername to use the default DDC table.
3. Type
ddctable '[servername]' nVidia
specified servername to use the nVidia DDC table.
NOTE: The servername is the name of the AMIQ module and should be entered exactly as it displays in the
target list. Single quotes are required before and after the servername. The following is an example of the
command for a typical configuration DDC table: ddctable 'Server 43' nVidia.
and press
End
key to view the unit name at the bottom of the tab. This unit name can be set
and press
and press
Chapter 4: Advanced Operations
and press to force the target user
Enter
to force the target user station to
Enter
to set the AMIQ module with the
Enter
to set the AMIQ module with the
Enter
43