Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CHA PTER
3
Power Up and LEDs
AMX5000 switch or AMX5010 switch
There are three groups of LEDs on the front panel of your AMX5000 switch or AMX5010
switch. Each green LED in the left group corresponds to a server port. Each LED illuminates
when the system or cascaded AMX switch is attached and powered up.
Figure 3.1: AMX5000 Switch
The green and amber LEDs in the center group indicate the status of your LAN connection.
When a valid IP connection is made to the network port of the AMX switch, the green LINK LED
blinks. The amber 100M LED indicates the speed of the attached LAN. This LED illuminates when
a 100M connection is made or remains unlit when a 10M connection is made. The green power
(PWR) LED in the center group illuminates when the AMX switch is powered and will blink only
during a FLASH upgrade.
Additional green LEDs in the right group correspond to each user port and illuminate when the
AMX5100 user station, AMX5110 user station, AMX5120 user station or cascaded (AMX5000 or
AMX5010) switch is attached and powered up.
AMX user station
There are two blue LEDs on the front panel of the AMX user station. The top LED is the power
status LED and remains constantly lit when power is connected and off when power is absent. The
lower LED shows connection and activity status. This LED blinks when the OSD is displayed and
remains constant when there is a valid connection between the AMX user station and an AMIQ
module or AMX switch.
Basic Operations
19
Publicité
Chapitres
Table des Matières
