Installation Of Glass Pane; Installing The Block Set - Dru VENTEO E Manuel D'installation Et D'entretien

INSTALLATION AND SERVICE MANUAL

7.2 Installation of glass pane

1. Take hold of the glass pane fi rmly with both hands. Place
the glass pane carefully between the construction frame
and into the interior (take care to avoid damage to
the construction frame!).
2. Place the underside of the glass pane onto the two rub-
bers provided for this purpose.
3. Tilt the glass pane gently backwards until it is standing
vertically in the appliance. Hold this fi rmly with one hand
in order to keep it in place.
4. Place the air inlet moulding inside the appliance (fi gure 9).
5. Position the right hand decorative strip (fi gure 10).
Position the left hand strip in the same way.
Figure 9
Figure 10

8. Installing the block set

2
1
Position the block set as illustrated in fi gures 11 to 15.
It is important that the blocks are laid out in the correct
manner in relation to the fl ame image! Ensure that the ap-
pliance is working when laying out the blocks. In this way it
can be determined whether the blocks have a detrimental
effect upon the fl ame image!
18
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15