Dru VENTEO E Manuel D'installation Et D'entretien page 24

INSTALLATION AND SERVICE MANUAL
Carefully remove the wiring harness and the IR-cable
from the clips with which it is attached (fi gure 22a). Re-
move the four self tapping screws with which the heater
unit is attached. Begin with the two self tapping screws
on the front, and then remove the two on the rear (fi -
gure 22b). Ensure that you support the heater unit with
one hand when removing the rearmost two self tapping
screws so that you can remove the entire unit from the
appliance in a controlled manner (fi gure 22c).
Remove the three self tapping screws holding the heating
set in the heating unit (fi gure 23a). You can now remove
the heating set (fi gure 23b) and fi nally disconnect the
wiring (fi gure 23c).
Figure 22b
Figure 22a
22
Figure 22c
Figure 23a
Figure 23b