Dru VENTEO E Manuel D'installation Et D'entretien page 22

INSTALLATION AND SERVICE MANUAL
The base is now loose between the side panels.
These can be removed (fi gure 17).
Remove the four self-tapping screws with which the
right hand side panel is attached (fi gure 18a). Remove
the right hand side panel carefully from the appliance
(fi gure 18b). Do the same with the left hand side panel.
Figure 17
Figure 18a
CAUTION! The fuses are mounted on the left hand side
pane. These do not need to be disconnected. The panel can
be carefully removed with the fuses and wiring attached.
Disconnect the three electricity wires as illustrated in
fi gure 19.
Remove the three self tapping screws with which the
fl ame unit is attached to the appliance (fi gure 20a).
Remove the fl ame unit carefully from the appliance
(fi gure 20b).
Remove the self tapping screws with which the back
plate is attached to the appliance (fi gure 21a). Carefully
remove the back plate (fi gure 21b)! Damage greatly
affects the fl ame image!
20
Figure 18b
Figure 19