Belkin N1 VISION Mode D'emploi page 95

Troubleshooting
• The Assistant software completed installation,
but my web browser doesn't work.
• I am unable to connect to the Internet. The "modem" icon
on my N1 Vision is on, and the "internet" icon is blinking.
1. If you cannot connect to the Internet, the "modem" icon is on, and the
"internet" icon is blinking, the problem may be that your connection
type may not match the ISP's connection.
2. If you have a "static IP address" connection, your ISP must assign you
the IP address, subnet mask, and gateway address. Please refer to the
section entitled "Alternate Setup Method" for details on changing this
setting.
3. If you have a "PPPoE" connection, your ISP will assign you a user
name and password and sometimes a service name. Make sure the N1
Vision's connection type is configured to PPPoE and the settings are
entered properly. Please refer to the section entitled "Alternate Setup
Method" for details on changing this setting.
4. You may need to configure your N1 Vision to meet the specific
requirements of your ISP. To search our knowledge base for ISP-specific
issues, go to: http://web.belkin.com/support and type in "ISP" into the
"Product Support Search" text box.
If you are still unable to access the Internet after verifying these settings,
please contact Belkin Technical Support.
93
1
2
3
4
5
6
7
8
9
10