Belkin N1 VISION Mode D'emploi page 56

Using the Web-Based
Advanced User Interface
1. Wi-Fi Protected Setup (WPS): Enabled or Disabled.
2. Personal Identification Number (PIN) Method: In this method, a wireless
client wishing to access your network must supply a 4- or 8-digit
PIN to the N1 Vision. After clicking "Enroll", you must start the WPS
handshaking procedure from the client within two minutes.
3. Router PIN: If an external registrar is available, you may enter in the N1
Vision's PIN to the registrar. Click "Generate New PIN" to change the
PIN from the default value. Click "Restore Default PIN" to reset the PIN
value.
4. Push Button Configuration (PBC) Method: PBC is an alternate method
to connect to a WPS network. Push the PBC button located on the back
of the N1 Vision for three seconds, and then initiate the PBC on the
client device. Alternatively, push the "Start PBC" soft button to start this
process.
5. Manual Configuration Method: This section lists the default security
settings if not using WPS.
The N1 Vision features WPA2, which is the second generation of the
WPA™ based 802.11i standard. It offers a higher level of wireless security
by combining advanced network authentication and stronger Advanced
Encryption Standard (AES) encryption methods.
54