Changing System Settings - Belkin N1 VISION Mode D'emploi

Using the Web-Based
Advanced User Interface

Changing System Settings

The "System Settings" page is where you can enter a new administrator
password, set the time zone, enable remote management, and turn on and off
the NAT function of the N1 Vision.
Setting or Changing the Administrator Password
The N1 Vision ships with NO password entered. If you wish to add a password
for greater security, you can set a password here. Write down your password
and keep it in a safe place, as you will need it if you need to log into the N1
Vision in the future. It is also recommended that you set a password if you plan
to use the remote management feature of your N1 Vision.
Changing the Login Time-Out Setting
The login time-out option allows you to set the period of time that you can
be logged into the N1 Vision's advanced setup interface. The timer starts
when there has been no activity. For example, imagine you have made some
changes in the advanced setup interface, then left your computer alone
without clicking "Logout". Assuming the time-out is set to 10 minutes, 10
minutes after you leave, the login session will expire. You will have to log into
the N1 Vision again to make any more changes. The login time-out option is
for security purposes and the default is set to 10 minutes.
Note: Only one computer can be logged into the N1 Vision's advanced setup
interface at one time.
79
1
2
3
4
5
6
7
8
9
10