Belkin N1 VISION Mode D'emploi page 38

Alternate Setup Method
Setting your Internet Service Provider (ISP) Connection Type to Dynamic IP
A dynamic connection type is the most common connection type found with cable
modems. Setting the connection type to "dynamic" in many cases is enough to
complete the connection to your ISP. Some dynamic connection types may require
a host name. You can enter your host name in the space provided if you were
assigned one. Your host name is assigned by your ISP. Some dynamic connections
may require that you clone the MAC address of the PC that was originally
connected to the modem.
1. Host Name – This space is provided to enter a host name that needs to be
visible to your ISP. Enter your host name here and click "Apply Changes" (3). If
your ISP did not assign you a host name, or you are not sure, leave this blank.
2. Change WAN MAC Address – If your ISP requires a specific MAC
address to connect to the service, you can enter a specific MAC address
or clone the current computer's MAC address through this link.
(2)
36
(1)
(3)