Troubleshooting Assistant Cd - Belkin N1 VISION Mode D'emploi

Connecting and Configuring your N1 Vision
Troubleshooting Assistant CD – Belkin has provided our Assistant
software to make installing your N1 Vision a simple and easy task. You
can use it to get your N1 Vision up and running in minutes. The Assistant
software requires that your Windows 2000, XP, or Vista computer be
connected directly to your cable or DSL modem and that the Internet
connection is active and working at the time of installation. If it is not,
you must use the "Alternate Setup Method" section in this User Manual
to configure your N1 Vision. Additionally, if you are using an operating
system other than Windows 2000, XP, or Vista, you must set up the N1
Vision using the "Alternate Setup Method" section in this User Manual.
A. Shut down any programs that are running on your computer at this time.
Turn off any firewall or Internet-connection-sharing software on your
computer.
B. Insert the CD into your computer. The Troubleshooting Assistant will
automatically appear on your computer's screen within 15 seconds.
Click on "Go" to run the Troubleshooting Assistant. Follow the
instructions there.
IMPORTANT: Run the Troubleshooting Assistant from the computer that
is directly connected to the Router from Step 1 – B.
24