Using The Web-Based Advanced User Interface; Changing Lan Settings - Belkin N1 VISION Mode D'emploi

Using the Web-Based
Advanced User Interface
Changing LAN Settings – All settings for the internal LAN
setup of the N1 Vision can be viewed and changed here.
1. IP Address – The "IP address" is the internal IP address of the N1 Vision.
The default IP address is "192.168.2.1". To access the advanced setup
interface, type this IP address into the address bar of your browser. This
address can be changed if needed. To change the IP address, type in the
new IP address and click "Apply Changes". The IP address you choose
should be a non-routable IP. Examples of a non-routable IP are:
192.168.x.x (where x is anything between 0 and 255)
10.x.x.x (where x is anything between 0 and 255)
2. Subnet Mask – There is no need to change the subnet mask. This is a unique,
advanced feature of your Belkin Router. It is possible to change the subnet
mask if necessary; however, do NOT make changes to the subnet mask unless
you have a specific reason to do so. The default setting is "255.255.255.0".
46
(1)
(2)
(3)
(4)
(5)
(6)