Figure 4 Transducer Installation; Figure 5 Connecting Transducers - Siemens SITRANS FUS1010 Guide Rapide

Quick Start Guide
(Not present on some
(Not present on
some models)
Orientation for
Single Beam
Transducer at
9 o'clock position
Orientation for
Dual Beam
Transducer at
10 & 2 o'clock
positions
11. Slide transducer into a mounting frame back end first aligning the angled edge of the transducer with the angled
edge of the mounting frame. Keep transducer from making contact with the pipe until it butts up against the
mounting frame stop. Push transducer down to mate with the pipe.
12. Tighten the transducer clamping screw to hold the transducer firmly in place. Repeat installation procedure for the
other transducer.
13. Open the Flow Display Computer top cover. Using a flat blade screwdriver, remove the Cable Strain Relief bracket (see
Figure 5 below).
14. Observing the upstream to downstream orientation, attach the UP and DN cables to the transducers and make snug.
Attach the other ends to the UP and DN terminals of the Flow Display Computer (see Figure 5 below).
15. Replace the Cable Strain Relief bracket. Close top cover
Flow Display Computer
Transducer Cable Inputs
Transducer Installation
Transducer Clamping
Transducer Clamping
Screw
Screw
Spring Clip
Spring Clip
models)
Front View
Transducer Cables Connected
To Flow Display Computer
Figure 5. Connecting Transducers
Spacer Bar Spacer Bar
Spacer Bar Spacer Bar
Platform and
Platform and
clamping screw
clamping screw
Spacer Bar
Reference Hole
Figure 4. Transducer Installation
Cable Strain
Relief bracket
To Downstream Transducer
To Upstream Transducer
To Downstream Transducer
To Upstream Transducer
1012 Series
1012 Series
Mounting Frame Mounting Frame
Mounting Strap Mounting Strap
Note: Operational
Note optional 2nd
2nd Mounting Strap
Mounting Strap
shown.
shown.
Larger pipes may Larger pipes may
need an additional
need an additional
strap for a more
strap for a more
secure mount
secure mount.
Channel 2
Channel 1
15