Information For Operators - MBM GF4772V Instructions Pour L'installation

1.

INFORMATION FOR OPERATORS

Foreword
Original instructions. This document has been drawn up in the mother language of the manufacturer (Italian).
The information it contains is for the sole use of the operator authorised to use the appliance in question.
Operators must be trained concerning all aspects regarding functioning and safety. Special safety prescriptions
(Obligations-Prohibitions-Dangers) are carried in a specific chapter concerning these issues. This document
cannot be handed over to third parties to take vision of it without written consent by the manufacturer. The text
cannot be used in other publications without the written consent of the manufacturer. The use of: Figures/Im-
ages/Drawings/Layouts inside the document, is purely indicative and can undergo variations. The manufacturer
reserves the right to modify it, without being obliged to communicate his acts.
Purpose of the document
Every type of interaction between the operator and the machine during its entire life cycle has been carefully assessed both
during designing and during preparation of this document. We therefore hope that this documentation can help to maintain
the characteristic efficiency of the appliance. By strictly keeping to the indications it contains, the risk of injuries while work-
ing and/or of economical damage is limited to a minimum.
How to read the document
The document is divided into chapters which gather by topics all the information required to use the appliance
in a risk-free way. Each chapter is divided into paragraphs; each paragraph can have titled clarifications with
subtitles and descriptions.
Keeping the document
This document is an integral part of the initial supply. It must therefore be kept and used appropriately during the
entire operational life of the appliance.
Addressees
This document is designed for the exclusive use of the homogeneous operator (trained and authorised tech-
nician) i.e. all the operators authorised to move, transport, install, maintain, repair and scrap the appliance.
Homogeneous operators are advised to read the service manual in order to have a general overview of the
information.
Operator training program
Upon specific demand by the user, a training course can be held for operators in charge of using the appliance,
following the modalities provided in the order confirmation.
Depending on the demand, preparation courses can be held at the site of manufacturer or of the user, for:
Homogeneous operator in charge of electric/electronic maintenance (specialised technician);
Homogeneous operator in charge of mechanical maintenance (specialised technician);
• Generic operator for simple operations (Operator - Final user).
Pre-arrangements depending on customer
Unless different contractual agreements were made, the following normally depend on the customer:
•
setting up the rooms (including masonry work, foundations or channelling that could be requested);
•
smooth, slip-proof floor;
•
pre-arrangement of installation place and installation of appliance respecting the dimensions indicated in
the layout (foundation plan);
•
pre-arrangement of auxiliary services adequate for requirements of the system (electrical mains, water-
works, gas network, drainage system);
•
pre-arrangement of the electrical system in compliance with the regulatory provisions in force in the place
of installation;
•
sufficient lighting, in compliance with the standards in force in the place of installation;
•
safety devices upstream and downstream of the energy supply line (residual current devices, equipotential
earthing systems, safety valves, etc.) foreseen by the legislation in force in the country of installation;
•
earthing system in conformity with the regulations in force in the place of installation
•
pre-arrangement of a water softening system, if needed (see technical details).
Contents of the supply
• Appliance
• Lid/s
• Metallic rack/s
• Rack support grid
• Pipes and/or wires for connections to energy sources (only when indicated in work order).
The supply may vary depending on the order.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 4 - 4