Positioning And Handling - MBM GF4772V Instructions Pour L'installation

3.

POSITIONING AND HANDLING

Obligations - Prohibitions - Advice - Recommendations
Upon receipt, open the machine packaging and ensure that the machine and accessories
have not been damaged during transportation. Where this is found to be the case, notify the
carrier immediately and do not proceed with installation but contact the qualified and author-
ised personnel. The manufacturer is not liable for damage caused during transportation.
Unauthorised persons (including children, disabled individuals and people with limited
physical, sensory and mental abilities) are prohibited from performing any procedures.
Read the instructions before acting.
Wear protective equipment suitable for the operations to be performed. As far as personal
protective equipment is concerned, the European Community has issued Directives which
the operators must comply with. Noise ≤ 70 dB
It is strictly forbidden to tamper with or remove the plates and pictograms applied to the
equipment.
Disconnect all supplies (electrical - gas - water) upstream the appliance whenever you
need to work in safe conditions.
Do not leave flammable objects or material near the appliance.
Particular safety prescriptions (obligation-prohibitions-danger) are detailed in the specific
chapter concerning these issues.
Whenever it is necessary to operate inside the appliance (connections, commission-
ing, checking operations, etc.) prepare for the necessary operations (removal of panels,
elimination of electric-gas-power supply) in compliance with the safety conditions.
Handling safety
Failure to follow the instructions reported below could result in exposure to the risk of seri-
ous injury.
Installation must be carried out by qualified and authorised technicians in accordance with
the laws in force and with the use of the appropriate materials described.
Wear personal protective clothing. This must meet the requirements of the EC directive on
personal protective equipment.
The operator authorised for the handling and installation operations of the appliance must
prepare, if necessary, a "safety plan" in order to ensure the safety of the persons involved
in the operations. In addition, they must follow and strictly and scrupulously implement the
laws and regulations relating to mobile sites.
Ensure that the lifting means adopted have capacity that is adequate for the loads to be
lifted and are in a good state of maintenance.
Perform the handling operations using lifting means with a capacity appropriate to the
weight of the appliance increased by 20%.
Follow the directions on the packaging and/or on the same appliance before handling
Check the centre of gravity of the load before lifting the appliance.
Lift the appliance to a minimum height from the ground in order to ensure its handling.
Do not stand or pass under the appliance during lifting and handling.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 9 - 9