6.
GAS TYPE CHANGEOVER
6.4 REPLACEMENT OF BURNER INJECTOR
•
Close the cut-off cock upstream the machine.
•
Unscrew the injector (Fig. 3)
•
Replace the injector (Fig. 1) with the one corresponding to the selected gas accor-
ding to what reported in the reference Table (see Gas reference Table).
•
Screw the new injector.
6.5 ADJUSTMENT OF MAIN BURNER
For primary air adjustment:
•
Close the cut-off cock upstream the machine.
•
Unscrew the locking screw (Fig. 1).
•
Where required set the distance (X) mm of the bushing corresponding to the se-
lected gas (see Gas reference Table).
Block the bushing with the screw and put a tampering detecting seal on it
•
Open the cut-off cock upstream the machine
•
Turn on the pilot burner and the main burner according to the instructions described in the ignition chapter
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
Fig. 1
Fig. 3
- 21 -
21
Fig. 1
Fig. 3
Fig. 1
X