Operating Controls - Hach ORBISPHERE 3654 Manuel D'utilisation De Base

Section 5 Operating Instructions
To avoid damaging the sensor, never remove the flow chamber during normal operation. The flow
chamber should only be removed during service procedures.

5.1 Operating controls

The front panel of the instrument has a three-digit liquid crystal display (LCD). The LCD includes a
right-side marker to distinguish between gas concentration and temperature display. This marker
also indicates the measurement display units (g/kg, V/V, etc.) depending on the instrument
configuration. To the LCD's right is a label showing the measurement units configured at the factory
for your application.
In addition to the controls indicated on the front panel, there is also a pressure relief valve on top of
the instrument. Refer to
the installation procedures, and/or if pressure builds up inside the instrument due to large
temperature changes.
The panel keyboard has the following push-button controls:
Power switch. This turns instrument power on or places in standby. When switched on,
the instrument performs a series of start-up procedures before switching to
measurement mode
Places the instrument in measurement mode
Calibrates the analyzer against a reference sample. This button can be locked out from
the Hach 3654 PC program
Stores a measurement value into memory
Backlights the LCD for approximately three minutes. Push repeatedly to increase the
backligth to the maximum value and back to minimum.
Toggles between gas concentration and temperature measurement displays in
measurement mode, increases or decreases the storage number during storage or
memory view, or sets a calibration value during calibration
You can access other instrument functions by pushing one of the following keys while also pressing
the power button:
N O T I C E
Instrument overview on page 8. This button need only be pressed as part of
English 13